The application frequency of faucet is very high, no matter in family life or outdoors, it is indispensable. Due to the frequent application, the frequency of problems is also very high, just as we often encounter faucet leakage. At this time, we need to disassemble the faucet to see if there is a problem with the valve core. If so, we need to replace it. But here, some colleagues are not very clear about the way to replace the faucet spool, so let's just say a few words. We can follow the steps below.

　　Alternative faucet spool steps:

　　1. Preparatory work

　　If the valve core is broken, first buy one to replace it. The replaced new valve core needs to be consistent with the faucet. In the ordinary environment, there are valve cores in the stores corresponding to the faucet brand, which can be bought. According to the screws of our faucet, prepare for a slotted or cross screwdriver, or an Allen wrench, a pointed nose pliers and a knife.

　　2. Remove the hot and cold water button

　　Before replacing the valve core, first find the water source switch of the faucet, and then turn it off to prevent spraying water during replacement. Then find the cold water button, perhaps a plastic cap, and pry it off with a small knife so that you can see the screws inside.

　　3. Remove handle

　　After opening the hot and cold water button, look at the style of the screw, whether it is a slotted screw, a cruciform screw, or a hexagonal screw, and then choose a similar screwdriver or an Allen wrench. Remove the screws in the hole with a screwdriver, and then remove the handle of the faucet.

　　4. Remove the spool

　　After removing the handle, you can see the valve core. There is another constant shell cover on the surface of some valve cores. Remove the cover. Then you can see the clip with the same valve core. There are usually four claws on the clip. Clamp the two claws with both ends of the pointed nose pliers, and then twist clockwise to remove the clip.

　　5. Equipment

　　After removing the clamp, you can remove the bad valve core, then equip the new valve core, reverse the process ahead, install and return the other components from the new one, install the faucet handle, punch in the water source valve, try whether there is water leakage, lock the handle when there is no problem, and install the cold and hot water plastic cap.

　　Article from:Kaiping faucet  http://www.kpxiangji.com/